OCMRacers-Forum

[zixxer]

Motor ....Go tech 3 port
Clutch.....Fioroni turbo-slide....carbon shoes 2 hard springs in rear 1 light spring in front
Tires ......Holeshot m-2
Front suspension
shock length center to center on the nuts 110mm
Blue OCM springs
45wt losi oil
toe out 1.25 deg
camber -1.25 deg
shock hole location upper middle,lower outside hole
0 deg insert anti-dive
0 deg inseert onboard toe-out
0 deg upper arm front insert
arms all the way forward(1 big spacer 1 little spacer)
Rear suspension set-up
1.75 deg toe-in
.5 up anti-squat
-1.25 camber
roll center middle inside hole on the tower ,middle hole on upright
shock hole location upper middle hole lower outside hole
blue OCM springs
2 up from the smallest pre-load spacer
40wt losi oil....
i set the droop screws by losening the lower shock screw and letting the arms fall then tightening the droop screws until the bottom of the shock where you run the screw through to the arm was even all the way through (credit john Ball for that) if thats not to confusing ...it worked really well and you get full range of the shock lenght without the chance of it pulling out .....really the buggy looked like alan was saying in one of his set-ups ...it seemed to sit a little forward ...the bones are a little above center in the rear and just a touch below center in front ......
_________________

[OCMRacer]

ayyy thanks for the info zixxer, could you post that in the set up section for next time please.

great stuff
_________________
http://www.freeforum101.com/ocmracing/ - OCMRacers-Forum
No.1 Support for your OCM
Run By Racers 4 Racers